Our products

Digital-to-Analog Converter –
• Converts RS485 Modbus to analog signal
• 4 isolated analog outputs (4-20mA or 0-10V)
• Fully configurable

The CRL20 network converter retrieves variables from a MODBUS network
and converts them into analog signals.

• Measurements: voltage, AC and DC current, and frequencies
• Fully configurable analog outputs
• Continuous and alternating measurement
• CPL23L: 1 analog output
• CPL23: 2 analog outputs
• Response time: <150 ms
The CPL23 is a programmable transmitter designed for electrical network measurements. It is fully user-
-configurable and can be used as a voltmeter, ammeter, or frequency meter.

• All process and temperature inputs
V, mV, mA, sensor power supply, potentiometer
, thermocouple, PT100

• Measurement display (10,000 points) and 4-digit unit display
(programming via front panel and RS232 interface)

• Two measurement channels (independent and isolated)

• Isolated analog output
• Universal power supply
The CNLR22/A is a 2-channel converter designed for 19″ rack mounting, featuring a display (measurement and units) and a fully programmable front-panel interface
.

• CNL35: universal input, over 10 types of inputs (temperature and process)
• CNL35/F: fixed-frequency input
• CNL35/R: relay option
• CNL35/S2: second output option
• CNL35/T: reduced response time
• CNL35/SP: 16-bit output

• Fully configurable
• Fully isolated
The CNL35 is a fully configurable, general-purpose digital transmitter for temperature and process inputs

• Process inputs (Volt, mA, sensor power supply, potentiometer)
• 2 isolated analog outputs
• CNL23L-H:

HART transparency option

• Fully configurable
• Simulation mode (RS-232) loop calibration

• Low response time: 55 ms
• Universal power supply: 20–265 V AC/DC
The CNL 23L is a process input transmitter featuring two isolated analog outputs
that can be configured independently (loop isolator, signal duplicator, load boost, etc.)

• Process inputs: Volts, mA, potentiometer

• Bipolar inputs and outputs (+/-)
• Fully configurable (RS-232)
• 2 analog outputs as standard
• Fast response time: 55 ms

The CNL 23 is a digital-to-analog converter for process inputs. Its quick reconfiguration without the need for adjustment makes it a cost-effective replacement for an analog converter.

• All process and temperature inputs: Volts, mV, mA, analog sensor, potentiometer; thermocouple, PT100

• CNLB20SI: DIN rail mounting
• CNLR20SI: 19″ rack mounting »

• Fully configurable
• Fully isolated 2500V

• RS485 Modbus connection

The CNL20SI is a programmable converter designed for use with sensors in Ex-
s. A single model covers all measurement needs in explosive environments.

• Process analog signal inputs (V, mA, sensor power supply, potentiometer)

• CAL23: Low-noise version, 35 mm wide

• CAL23L: Compact 23 mm version (switching power supply)

• SVL23: Maximum Value Selector Version (between two inputs of the same type)

• Triple galvanic isolation
• Bandwidth up to 10 kHz

The CAL23 signal conditioner is designed to adapt and isolate a wide range of electrical process signals.
Triple galvanic isolation (input/output/power supply) ensures optimal safety regardless of how the conditioner is used.